Mazda 3 Service Manual: Power Brake Unit Removal/Installation [Mzr 2.3 Disi Turbo]
CAUTION:
-
Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again. Therefore, replace the switch with a new one when replacing the power brake unit or performing any procedure that changes the pedal stroke.
-
Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.
1. Remove the battery and battery tray..
2. Remove the master cylinder..
3. Loosen the brake pipe flare nuts as shown in the figure.
4. Move the brake pipes as shown in the figure.
5. Disconnect the steering shaft from the steering gear and linkage..
6. Remove in the order indicated in the table.
7. Remove the brake switch..
8. Install in the reverse order of removal.
9. After installation, inspect the brake pedal..
|
1 |
Vacuum hose |
|
2 |
Joint pin (See BRAKE PEDAL REMOVAL/INSTALLATION.) |
|
3 |
Nut |
|
4 |
Power brake unit |
|
5 |
Gasket |
Power Brake Unit Removal/Installation [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
CAUTION:
Once the brake switch clearance has automatically been adjusted, it cannot
be adjusted again. Therefore, replace the switch with a new one when replacing
the power brake unit or ...
Vacuum Hose Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery and battery tray..
2. Remove the vacuum hose from the vacuum hose clip.
3. Insert a thin flathead screwdriver at the point indicated by the arrow in
the figure, push th ...
Other materials:
Locking, Unlocking with Request
Switch (With the advanced keyless
function)
All doors and the liftgate can be locked/
unlocked by pressing the request switch
on the front doors while the key is being
carried.
(5–door)
The request switch on the liftgate can only
be used to lock all doors and the liftgate.
Front doors
Liftgate (5-door Lock only)
To lock
To l ...
How to Use the Bluetooth ® Audio
System
Switching to Bluetooth ® audio mode
To listen to music or voice audio recorded
to a Bluetooth ® audio device, switch to
the Bluetooth ® audio mode to operate
the audio device using the audio system
control panel. Any Bluetooth ® audio
device must be paired to the vehicle's
Bluetooth ® unit be ...
Liftgate Opener Switch Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate lower trim.
d. Liftgate latch and lock actuator.
3. Disconnect the connector.
4. Pull out the retainer in the direction of the arrow.
5. Remove the ...
