Mazda 3 Service Manual: Power Steering Fluid Line Component Removal/Installation
NOTE:
-
The following procedure is for replacement of the parts shown in the figure. Regarding replacement of the suction hose and return hose, refer to the electric power steering oil pump component removal/installation..
Power Steering Pipe Component Removal/Installation
NOTE:
-
The pressure pipe and return pipe are integrated with the power steering pipe component. Therefore, if any one of the pipes has a malfunction, replace the power steering pipe component.
1. Remove the front mudguard (RH)..
2. Remove the splash shield and aerodynamic under cover NO.2 as a single unit..
3. Remove the connecting bolt (pump side) from the electric power steering oil pump and disconnect the return hose from the power steering pipe component (return pipe).
NOTE:
-
Drain the power steering fluid.
4. Remove the nut shown in the figure.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
|
1 |
Bolt |
|
2 |
Connecting bolt (steering gear side) |
|
3 |
Hose clips |
|
4 |
Power steering pipe component |
Power Steering Fluid Inspection
Fluid Level Inspection
1. Verify that the fluid level is between MAX and MIN of the sub tank when the
engine is cold.
If the fluid is not at the specified level, adjust the fluid level (MIN ...
Steering Shaft Inspection
1. Inspect the column bearing for excessive play and damage.
2. Verify that the measurement of the steering shaft indicated in the figure
is as specified.
If not within the specificati ...
Other materials:
How to Use Pandora
What is Pandora ® ?
Pandora ® is free personalized Internet radio. Simply enter a favorite
artist, track, genre,
and Pandora ® will create a personalized station that plays their music and more
like it.
Rate songs by giving thumbs-up and thumbs-down feedback to further refine your
station ...
Rear Drain Hose Removal
1. Disconnect the negative battery cable.
2. Remove the rain sensor cover. (Vehicles with auto light/wiper system).
3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)
4. Partially peel back the seaming welt.
5. Remove the following parts:
a. Sunroof seaming w ...
General Procedures (Steering)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
88—118 N·m {9.0—12 kgf·m, 65—87 ft·lbf}
Connector Disconnection
1. Disconnect the negative battery cable ...
