Mazda 3 Service Manual: Power Window Motor Inspection
Front Driver Side
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Disconnect the power window motor connector.
5. Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor operation.
-
If the power window motor does not operate as indicated in the table, replace the power window motor.
|
Operation |
Terminal |
|
|
E |
F |
|
|
Open |
Ground |
B+ |
|
Close |
B+ |
Ground |
6. Connect the battery positive voltage to power window motor terminal D and connect terminal C to ground.
7. Operate the power window motor and measure the voltage at terminals A and B.
-
If there is any malfunction, replace the power window motor.
-
Voltage
-
Pulse: max. 5 V/min. 0 V
Front Passenger Side
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Disconnect the power window motor connector.
5. Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor operation.
-
If the power window motor does not operate as indicated in the table, replace the power window motor.
|
Operation |
Terminal |
|
|
E |
F |
|
|
Open |
Ground |
B+ |
|
Close |
B+ |
Ground |
Rear
1. Disconnect the negative battery cable..
2. Remove the rear door trim..
3. Disconnect the power window motor connector.
4. Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor operation.
-
If the power window motor does not operate as indicated in the table, replace the power window motor.
|
Operation |
Terminal |
|
|
E |
F |
|
|
Open |
Ground |
B+ |
|
Close |
B+ |
Ground |
Power Window Main Switch Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the inner garnish. (driver's side).
3. Remove the front door trim. (driver's side).
4. Remove the power window main switch..
5. Ins ...
Power Window Motor Removal/Installation
Front Power Window Motor
1. Fully lower the front door glass.
2. Disconnect the negative battery cable..
3. Remove the inner garnish..
4. Remove the front door trim..
5. Remove the front door ...
Other materials:
Knock Sensor (Ks) Inspection [Mzr 2.0, Mzr 2.5]
Resistance Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Disconnect the KS connector.
4. Measure the resistance between KS terminals A and B.
If not as specified, replace the KS..
Specification
Approx. 4.87 megohms [normal tem ...
Active Command Modes Inspection [Instrument Cluster]
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the IDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “IC”.
3. Select the simulation items from the PID table.
4. Perform the active c ...
Front Bumper Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the screw A and fasteners B.
3. Remove the screws C.
4. Remove the bolts D.
5. Remove the fasteners E, screw F and fastener G.
6. Pull the front bumper in the direction of the arrow in the order of (1), (2)
and (3), the ...
