1. Disconnect the negative battery cable..
2. Spread open the rain sensor cover in the direction of the arrows and disengage tabs A to remove it.
3. Disconnect the rain sensor connector.
4. Slide rain sensor tab B in the direction of the arrow shown in the figure and detach tab B.
5. Remove the rain sensor in the direction of the arrow shown in the figure.
6. Peel off the rain sensor protective sheet from the rain sensor.
7. Install in the reverse order of removal..
Rain Sensor Installation Note
CAUTION:
If the rate at which the rain sensor reflects or transmits infrared light between the rain sensor and the windshield, or through the protective sheet is changed, the rain sensor will determine that there is a malfunction in the rain detection function and stop auto wiper system control. Be careful of the following when installing the rain sensor:
Do not reuse rain sensor protective sheet
Do not touch rain sensor lens, rain sensor protective sheet, and sensor installation area on windshield with your finger
Verify that there is no air bubble after installing rain sensor
1. Wipe off any oil or dirt from the rain sensor lens and the windshield using a clean rag.
2. Peel off double-sided adhesive tape A from the rain sensor protective sheet.
3. Adhere the rain sensor protective sheet to the rain sensor lens.
4. Peel off double-sided adhesive tape B from the rain sensor protective sheet.
5. Install the rain sensor.
6. Press the rain sensor in the direction of the windshield and press out any air bubbles.
7. Verify that there is no air bubble between the windshield and the rain sensor.
Tire Pressure Monitoring System
The Tire Pressure Monitoring System (TPMS) monitors the air pressure of all
four tires. If
the air pressure of one or more tires is too low, the system warns the driver by
indicating the
tire pressure monitoring system warning light in the instrument cluster and
operating a beep
sound. The ...
Key Reminder Switch Inspection
1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR
2.0, MZR 2.5].)(See BATTERY REMOVAL/INSTALLATION [MZR 2.3 DISI Turbo].)(See BATTERY
REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION.)
3. Disconnect the ...
Manual Transaxle Removal/Installation [A26 M R]
CAUTION:
Secure the steering wheel using tape or a cable to prevent the steering shaft
from rotating after disconnecting the steering shaft. If the steering wheel
rotates after the steering shaft and the steering gear and linkage are disconnected,
the internal parts of the clock spr ...