Mazda 3 Service Manual: Rear Coil Spring Removal/Installation
1. Disconnect the auto leveling sensor lower side. (Vehicles with AFS).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the wheel alignment and adjust it if necessary..
|
1 |
Rear stabilizer control link upper nut |
|
2 |
Rear lower arm outer bolt . |
|
3 |
Rear coil spring . |
|
4 |
Upper spring seat rubber |
Rear Lower Arm Outer Bolt Removal Note
1. Rotate the rear stabilizer component downwards as shown in the figure.
2. Support the rear lower arm using a jack.
3. Loosen the rear lower arm inner bolt.
4. Remove the rear lower arm outer bolt.
Rear Coil Spring Installation Note
1. Position the jack under the rear lower arm and jack up slowly.
WARNING:
-
Installing the coil spring is dangerous. The coil spring could fly off and cause serious injure or death, and damage the vehicle.
2. Align the upper end of the rear coil spring with the step of the upper spring seat rubber.
3. Align the lower end of the rear coil spring with the step of the lower spring seat rubber.
4. Install the lower arm outer bolt.
Rear Suspension
...
Rear Lateral Link Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the wheel alignment and adjust it if necessary..
1
Rear stabiliz ...
Other materials:
Blind Spot Monitoring (Bsm) Off Switch Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the switch panel in the direction of the arrow shown in the figure.
3. Disconnect the connector.
4. Remove the BSM OFF switch in the direction of the arrow (2) shown in the figure
while pressing the tabs in the direction of the arrow ...
Oil Seal (Differential) Replacement [Fw6 A EL]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single
unit..
2. Remove the oil seal.
a. Drain the ATF..
b. Disconnect the drive shaft (LH) from the transaxle..
c. Disconnect the drive shaft (RH) from the joint shaft..
d. Remove the joint shaft..
CAUTION:
...
Cowl Grille Removal/Installation
1. Remove the windshield wiper arm and blade..
2. Remove the fastener A.
3. Pull the front fender molding in the direction of the arrow shown in the figure
and remove it while remove the tab B and tab C.
4. Disconnect the windshield washer hose from the joint pipe A..
5. Remove the fas ...
