Mazda 3 Service Manual: Rear Door Quarter Glass Removal/Installation
1. Fully lower the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the rear door trim..
4. Remove the service hole cover.
5. Remove the hole plug.
6. Remove the screw.
7. Remove the bolt A and B.
8. Remove the rear door glass guide.
9. Remove the pin. (5HB)
10. Slide the rear door quarter glass in the direction of the arrow (1) shown in the figure.
11. Remove the rear door quarter glass and rear door quarter glass guide as a single unit in the direction of the arrow (2) shown in the figure.
12. Remove the rear door quarter glass from the rear door quarter glass guide.
13. Install in the reverse order of removal.
Rear Door Glass Removal/Installation
1. Fully lower the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the rear door trim..
4. Remove the rear door speaker..
5. Remove the rear power window motor..
6. Rem ...
Rear Power Window Regulator Removal/Installation
1. Fully lower the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the rear door trim..
4. Remove the service hole cover.
5. Remove the rear door speaker..
6. Remov ...
Other materials:
Fuse Replacement
Replacing the fuses on the vehicle's left side
If the electrical system does not work, first
inspect the fuses on the vehicle's left side.
Make sure the ignition is switched off,
and other switches are off.
Open the fuse panel cover.
Pull the fuse straight out with the
fuse pul ...
Operating Tips for CD Player
Condensation phenomenon
Immediately after turning on the heater
when the vehicle is cold, the CD or
optical components (prism and lens) in
the CD player may become clouded with
condensation. At this time, the CD will
eject immediately when placed in the unit.
A clouded CD can be corrected s ...
Clutch Release Cylinder Removal/Installation [C66 M R]
CAUTION:
Do not allow clutch fluid get on a painted surface. Clutch fluid contains
properties which can dissolve the paint. If clutch fluid gets on a painted surface,
wash it off with water immediately and wipe the area off completely.
1. Remove the aerodynamic under cover No.2.. ...
