1. Remove the rear seat cushion..
2. Remove the rear buckle installation bolt..
3. Remove the rear seat back..
4. Remove the headrest.
5. Open the fasteners.
6. Detach the hooks.
7. Remove the child-restraint seat anchor covers in the order of (1), (2) as shown in the figure. (5HB only)
8. Remove the push knob while remove the hooks in the direction of arrow shown in the figure.
9. Open the fastener, remove the fastener and striker cover.
10. Remove the bolt then remove the rear seat center armrest.(Vehicles with the rear seat center armrest)
11. Peal back the rear seat pad, release the pole guide tabs in the direction of arrow (3) shown in the figure, then pull out the pole guides in the direction of arrow (4).
12. Remove the screws, then remove the belt cover in the direction of arrow shown in the figure.
13. Open the fasteners.
14. Remove the seat back frame from the seat back pad by pulling it in the direction of the arrow.(5HB)
15. Remove the nut, then remove the rear seat belt.
16. Install in the reverse order of removal.(5HB)
Precaution [ABS]
1. Any one or a combination of the ABS warning and brake system warning lights
illuminates even when the system is normal.
Warning lights that may illuminate and/or flash
Cases in which the light may illuminate
Conditions in which the light will go ou ...
Rain Sensor Removal/Installation
1. Disconnect the negative battery cable..
2. Spread open the rain sensor cover in the direction of the arrows and disengage
tabs A to remove it.
3. Disconnect the rain sensor connector.
4. Slide rain sensor tab B in the direction of the arrow shown in the figure
and detach tab B. ...
Receiver/Drier Removal/Installation
MZR 2.0, MZR 2.5, SKYACTIV-G 2.0
1. Disconnect the negative battery cable..
2. Discharge the refrigerant..
3. Remove the aerodynamic under cover No.2..
4. Remove the aerodynamic under cover No.1..
5. Remove the front bumper..
6. Disconnect the block joint type pipes by grasping female sid ...