Mazda 3 Service Manual: Rear Seat Cushion Trim Removal/Installation
1. Remove the rear seat cushion..
2. Remove rings C, then remove the seat cushion trim from the seat cushion pad.
3. Install in the reverse order of removal.
Rear Seat Cushion Removal/Installation
1. Detach the hooks from the grommets by pulling the rear seat cushion in the
order of (1), (2) in the direction of the arrow shown in the figure, while remove
the wire.
2. Install in the re ...
Rear Tilt Motor Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable and wait 1 min or more..
3. Disconnect the rear tilt motor connector.
4. Apply battery positive voltage to the rear tilt mo ...
Other materials:
Rear Bumper Disassembly/Assembly
1. Remove the License plate lights..
2. Disassemble in the order indicated in the table.
1
Fastener A
2
Bracket
3
Screw B
4
Reflector
(See Reflector Removal Note)
5 ...
Using Automatic Locking Mode
Follow these instructions when using a child-restraint system, unless you are
attaching a LATCH-equipped childrestraint system to the rear LATCH lower
anchors. Refer to “Using LATCH Lower Anchor” .
NOTE
Follow the child-restraint system
manufacturer's instructions carefully.
If you are not ...
Manual Transaxle Removal/Installation [G66 M R]
CAUTION:
Secure the steering wheel using tape or a cable to prevent the steering shaft
from rotating after disconnecting the steering shaft. If the steering wheel
rotates after the steering shaft and the steering gear and linkage are disconnected,
the internal parts of the clock spr ...
