Mazda 3 Service Manual: Rear Stabilizer Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
|
1 |
Rear stabilizer control link |
|
2 |
Rear stabilizer bracket . |
|
3 |
Rear stabilizer bushing (See Rear Stabilizer, Rear Stabilizer Bushing and Rear Stabilizer Bracket Installation Note.) |
|
4 |
Rear stabilizer (See Rear Stabilizer, Rear Stabilizer Bushing and Rear Stabilizer Bracket Installation Note.) |
Rear Stabilizer, Rear Stabilizer Bushing and Rear Stabilizer Bracket Installation Note
1. Install the rear stabilizer bushing so that the projection points to the left side of the vehicle.
2. Install the rear stabilizer bracket.
3. Install the rear stabilizer component to the vehicle.
Rear Stabilizer Control Link Inspection
1. Remove the rear stabilizer control link from the vehicle..
2. Inspect for bending or damage. If there is any malfunction, replace the rear
stabilizer control link.
3. Rotate the ball joint st ...
Rear Upper Arm Removal/Installation
1. When working on the right side of the vehicle, disconnect the canister vent
(CV) solenoid valve from the rear crossmember. (MZR 2.0 (Except Mexico), SKYACTIV-G
2.0, MZR 2.3 DISI Turbo, MZR 2.5 ...
Other materials:
Front Brake (Disc) Inspection
Brake Judder Repair Hints
Description
1. Brake judder concern has the following 3 characteristics:
Steering wheel vibration
1. The steering wheel vibrates in the rotation direction. This characteristic
is most noticeable when applying brakes at a vehicle speed of 100—140 km/h {62.2—86.9
mph ...
Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air
Conditioner]
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Front side trim.
c. Dashboard under cover.
d. Upper panel.
e. Shift lever knob (MTX).
f. Selector lever knob (ATX).
g. Shift panel.
h. Side wall.
i. Console.
j. Hood release lever ...
Air Filter Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the fuel-filler pipe protector..
2. Remove in the order indicated in the table.
1
Evaporative hose
2
Air filter
3. Install in the reverse order of removal. ...
