Mazda 3 Service Manual: Rear Suspension

Wheel Hub, Steering Knuckle Removal/Installation

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Rear Coil Spring Removal/Installation

1. Disconnect the auto leveling sensor lower side. (Vehicles with AFS). 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the wheel alignment ...

Other materials:

Coolant Reserve Tank Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Relay Block Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Hood release lever. d. Upper panel. e. Shift knob (MTX)(See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R].)(See MANUAL TRANSAX ...

Passenger Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. NOTE: When replacing the passenger-side air bag module af ...