Mazda 3 Service Manual: Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the front mudguard (RH)..
3. Disconnect rear washer hose A from the washer motor.
4. Remove the rear washer hose A from clip A, B, C, D, E, F, G.
5. Disconnect joint pipes and remove rear washer hose A.
6. Partially peel back the seaming welts.
7. Remove the following parts:
a. Sunroof seaming welt (vehicles with sunroof only)
b. A–pillar trims.
c. Front scuff plate.
d. Rear scuff plate.
e. B-pillar lower trim.
f. Upper anchor of the front seat belt.
g. B–pillar upper trim.
h. Rear seat cushion.
i. Tire house trim.
j. Trunk side upper trim.
k. C–pillar trim.
l. Map light.
m. Interior light.
n. Sunvisor.
o. Assist handle.
p. Headliner.
8. Peel off the tape and remove rear washer hose B.
9. Remove the liftgate upper trim..
10. Partially peel back the grommet.
11. Remove the bracket in the direction of the arrow (2) shown in the figure while pressing the bracket tabs in the direction of the arrow (1).
12. Remove the rear washer hose C from clip H, I, J, K.
13. Disconnect joint pipes and remove rear washer hose C.
14. Disconnect check valve and remove rear washer hose C.
15. Remove rear washer hose D from the rear washer nozzle.
16. Install in the reverse order of removal.
Washers
...
Rear Washer Nozzle Adjustment
1. Insert a needle or an equivalent tool into the spray hole of the rear washer
nozzle and adjust the nozzle direction as shown.
...
Other materials:
Front ABS Wheel Speed Sensor Inspection
Sensor Output Value Inspection
CAUTION:
Resistance inspection using other testers may cause damage to the ABS wheel-speed
sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed
sensor.
1. Switch the ignition to off.
2. Connect the M-MDS to the DLC-2. ...
Precaution [ABS]
1. Any one or a combination of the ABS warning and brake system warning lights
illuminates even when the system is normal.
Warning lights that may illuminate and/or flash
Cases in which the light may illuminate
Conditions in which the light will go ou ...
Dynamic Stability Control
(DSC)
The Dynamic Stability Control (DSC)
automatically controls braking and engine
torque in conjunction with systems such
as ABS and TCS to help control side slip
when driving on slippery surfaces, or
during sudden or evasive maneuvering,
enhancing vehicle safety.
Refer to ABS and TCS .
DSC ...
