Mazda 3 manuals

Mazda 3 Service Manual: Rear Washer Nozzle Removal/Installation

Mazda 3 Service Manual / Body / Wipers, Washers / Washers / Rear Washer Nozzle Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Liftgate upper trim.

b. Rear spoiler.

c. High-mount brake light.

3. Disconnect the rear washer hose.

4. Press the tabs and remove the rear washer nozzle.


5. Install in the reverse order of removal.

6. Adjust the rear washer nozzle..

Rear Washer Nozzle Adjustment
1. Insert a needle or an equivalent tool into the spray hole of the rear washer nozzle and adjust the nozzle direction as shown. ...

Washer Motor Inspection
1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Disconnect the washer motor connector. 4. After connecting washer motor terminal A to the positive battery termi ...

Other materials:

Traction Control System (TCS)
The Traction Control System (TCS) enhances traction and safety by controlling engine torque and braking. When the TCS detects driving wheel slippage, it lowers engine torque and operates the brakes to prevent loss of traction. This means that on a slick surface, the engine adjusts automatic ...

Oil Cooler Removal/Installation [Fw6 A EL]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover NO.2.. 4. Drain the ATF.. 5. Drain the engine coolant.. 6. Remove in the order indicated in the table. 1 Water hose (connected to the water pipe) ...

i-ACTIVSENSE
i-ACTIVSENSE is a collective term covering a series of advanced safety and driver support systems which make use of a Forward Sensing Camera (FSC) and radar sensors. These systems consist of active safety and pre-crash safety systems. These systems are designed to assist the driver in safer ...

© 2016-2024 Copyright www.mazda3tech.com