WARNING Do not stack cargo or objects higher than the seatbacks: Cargo stacked higher than the seatbacks is dangerous. It can block your view in the rearview mirror, which might cause you to hit another car when changing lanes. |
Rearview mirror adjustment
Before driving, adjust the rearview mirror to center on the scene through the rear window.
NOTE For the manual day/night mirror, perform the adjustment with the day/night lever in the day position.
Reducing glare from headlights
Manual day/night mirror
Push the day/night lever forward for day driving. Pull it back to reduce glare of headlights from vehicles at the rear.
Auto-dimming mirror
The auto-dimming mirror automatically reduces glare of headlights from vehicles at the rear when the ignition is switched ON.
(With Homelink wireless control system)
Press the OFF button to cancel the automatic dimming function. The indicator light will turn off.
To reactivate the automatic dimming function, press the ON button . The indicator light will illuminate.
(Without Homelink wireless control system)
Press the ON/OFF button to cancel the automatic dimming function. The indicator light will turn off.
To reactivate the automatic dimming function, press the ON/OFF button . The indicator light will illuminate.
NOTE
Otherwise, light sensor sensitivity will be affected and may not operate normally.
(With Homelink wireless control system)
(Without Homelink wireless control system)
Refer to HomeLink Wireless Control System on .
Gps Antenna Feeder Inspection
With Audio Unit (Without Display)
1. Verify that the continuity is as indicated in the table.
If not as indicated in the table, replace the GPS antenna feeder.
With Audio Unit (With Display)
NOTE:
GPS antenna feeder is integrated with the antenna feeder No.4.
1. ...
Drive Shaft (Tripod Joint) Disassembly/Assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
1
Boot band (transaxle side)
(See Boot Band (Transaxle Side) Disassembly Note.)
(See Boot Band (Transaxle Side) Assembly Note.)
2
Cli ...
Front Door Key Cylinder Removal/Installation
1. To access the glass installation bolt, position the front door glass so that
the distance from the top of the front door glass to the upper part of the front
beltline molding is approx. 80 mm {3.1 in}.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inne ...