Mazda 3 manuals

Mazda 3 Owners Manual: Recommended Oil

U.S.A., Canada, and Puerto Rico

Use SAE 0W-20 engine oil.

Mazda Genuine Oil is used in your Mazda vehicle. Mazda Genuine 0W-20 Oil is required to achieve optimum fuel economy.

For maintenance service, Mazda recommends Mazda Genuine Parts and Castrol ® (U.S.A. only).

Mazda 3. Recommended Oil


Only use SAE 0W-20 oil “Certified For Gasoline Engines” by the American Petroleum Institute (API).

Oil with this trademark symbol conforms to the current engine and emission system protection standards and fuel economy requirements of the International Lubricant Standardization and Approval Committee (ILSAC), comprised of U.S. and Japanese automobile manufacturers.

Mazda 3. Recommended Oil


Except U.S.A., Canada, and Puerto Rico

Use SAE 5W-30 engine oil.

Oil container labels provide important information.

A chief contribution this type of oil makes to fuel economy is reducing the amount of fuel necessary to overcome engine friction.

For maintenance service, Mazda recommends Mazda Genuine Parts and Castrol ® (Mexico only).

Mazda 3. Except U.S.A., Canada, and Puerto Rico


(Mexico)

Use SAE 5W-30 engine oil. If SAE 5W-30 engine oil is not available, use SAE 5W-20 engine oil.

The quality designation SM, or ILSAC must be on the label.

Mazda 3. Mexico


Engine Oil
NOTE Changing the engine oil should be performed by an Authorized Mazda Dealer. Refer to Introduction for owner's responsibility in protecting your investment. ...

Vehicle Engine Control Unit Reset Procedure
NOTE This procedure is intended for vehicles with the engine oil flexible maintenance setting selected. After replacing the engine oil, have a repair shop such as an Authorized Mazda Dealer pe ...

Other materials:

Speedometer
The speedometer indicates the speed of the vehicle. Speed Unit Selector (Type A Instrument Cluster) In some countries, you may have to change the speed units between km/h and mph. Press the speed unit selector for 1.5 seconds or more. The speed units for the speedometer will change bet ...

Wheel Hub Component Inspection
Wheel Bearing Excessive Play Inspection 1. Remove the brake caliper component and disc plate.. 2. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play. If it exceeds the maximum specification, replace the wheel hub compon ...

Drive Belt Removal/Installation [Mzr 2.0, Mzr 2.5]
MZR 2.0 A/C drive belt removal 1. Remove the aerodynamic under cover No.2 and splash shield as a single unit.. 2. Remove the nut shown in the figure and set the power steering pipe component out of the way. 3. Set the SST as shown in the figure. NOTE: Hold the SST by hand unti ...

© 2016-2024 Copyright www.mazda3tech.com