Mazda 3 Owners Manual: Replacing Windshield Wiper Blades
When the wipers no longer clean well, the blades are probably worn or cracked.
Replace them.
| CAUTION To prevent damage to the wiper arms and other components, do not try to sweep the wiper arm by hand. |
NOTE When raising both windshield wiper arms, raise the driver's side wiper arm first.
When lowering the wiper arms, slowly lower the wiper arm from the passenger's side first while supporting it with your hand. Forcefully lowering the wiper arms could damage the wiper arm and blade, and may scratch or crack the windshield.
- Raise the wiper arm.
- Open the clip and slide the blade assembly in the direction of the arrow
- Tilt the blade assembly and remove it from the arm.
| CAUTION To prevent damage to the windshield let the wiper arm down easily, do not let it slap down on the windshield. |
- Pull down the blade rubber and slide it out of blade holder.
- Remove the metal stiffeners from each blade rubber and install them in the new blade.
CAUTION
|
- Carefully insert the new blade rubber.
Then install the blade assembly in the reverse order of removal.
Wiper Blades
CAUTION
Hot waxes applied by automatic car
washers have been known to aff ect the
wiper's ability to clean windows.
To prevent damage to the wiper blades,
do not use gasolin ...
Replacing Rear Window Wiper Blade (5-Door)
When the wiper no longer cleans well, the
blade is probably worn or cracked.
Replace it.
CAUTION
To prevent damage to the wiper arm
and other components, do not move
the wiper by ...
Other materials:
Rear Seat Back Frame Removal/Installation
1. Remove the rear seat cushion..
2. Remove the rear buckle installation bolt..
3. Remove the rear seat back..
4. Remove the headrest.
5. Open the fasteners.
6. Detach the hooks.
7. Remove the child-restraint seat anchor covers in the order of (1), (2) as
shown in the figure. (5H ...
Steering Shaft Inspection
1. Inspect the column bearing for excessive play and damage.
2. Verify that the measurement of the steering shaft indicated in the figure
is as specified.
If not within the specification replace the steering shaft component.
Steering shaft length
315—320 mm {12.41—12.59 ...
Outer Mirror Garnish Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the outer mirror glass from the outer mirror..
3. Pinch the end of the tab which is visible, and release the tab by pressing
it toward the vehicle front (3 locations).
4. Grasp the upper side of the outer mirror garnish and remove it b ...
