Mazda 3 Service Manual: Rollover Valve Inspection [Mzr 2.0, Mzr 2.5]

Quick Release Connector (Emission System) Removal/Installation [Mzr 2.0, Mzr 2.5]

Quick Release Connector Type CAUTION: Verify the type and location, and install/remove properly. Except for Mexico Mexico Type A Removal CAUTION: Be careful not to da ...

Rollover Valve Removal/Installation [Mzr 2.0, Mzr 2.5]

NOTE: The rollover valve cannot be removed as it is built into the fuel tank. 1. Remove the fuel tank.. ...

Other materials:

Battery Replacement
If the buttons on the transmitter are inoperable and the operation indicator light does not flash, the battery may be dead. Replace with a new battery before the transmitter becomes unusable. CAUTION Make sure the battery is installed correctly. Battery leakage could occur if ...

Roof Carrier Bracket Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Sunroof seaming welt (vehicles with sunroof) b. Front scuff plate. c. Rear scuff plate. d. A-pillar trim. e. B-pillar lower trim. f. Upper anchor of the front seat belt installation bolt. g. B-pillar up ...

Compression Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Hot engines and oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component. Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel ...