Mazda 3 Service Manual: Seats
- Active Headrest Inspection
- Child Restraint Seat Anchor Removal/Installation
- Front Seat Back Component [Vehicles Without Power Seat System] Removal/Installation
- Front Seat Back Trim Removal/Installation
- Front Seat Cover Removal/Installation [Vehicles With Power Seat System]
- Front Seat Cover Removal/Installation [Vehicles Without Power Seat System]
- Front Seat Cushion Trim Removal/Installation
- Front Seat Rail Guide Cover Removal/Installation
- Front Seat Removal/Installation
- Front Seat Slide Adjuster Removal/Installation
- Front Tilt Motor Inspection
- Rear Center Seat Belt Removal/Installation
- Rear Seat Back Frame Removal/Installation
- Rear Seat Back Removal/Installation
- Rear Seat Back Trim Removal/Installation
- Rear Seat Cushion Removal/Installation
- Rear Seat Cushion Trim Removal/Installation
- Rear Tilt Motor Inspection
- Recliner Motor Inspection
- Seat Track Position Sensor Removal/Installation [Two Step Deployment Control System]
- Seat Warmer Switch Inspection
- Seat Warmer Switch Removal/Installation
- Seat Warmer Unit Inspection
- Seat Warmer Unit Removal/Installation
- Seat Weight Sensor Calibration [Two Step Deployment Control System]
- Seat Weight Sensor Control Module Removal/Installation [Two Step Deployment Control System]
- Seat Weight Sensor Inspection [Two Step Deployment Control System]
- Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]
- Slide Motor Inspection
- Power Seat Switch Inspection
Roof Molding Removal
1. Insert a fastener remover in the position shown in the figure.
2. Rotate the flathead screwdriver in the direction of the arrow (1) shown in
the figure and remove the roof molding from the T-st ...
Active Headrest Inspection
1. Push the bottom of front seat back in the direction of arrow shown in the
figure.
2. While inspecting for move the front seat back. ...
Other materials:
Theft Deterrent System Reading Freeze Frame Data
1. Connect the M-MDS (IDS) to the DLC–2.
2. After the vehicle is identified, select the following items from the initialization
screen of the IDS.
Select “Body”.
Select "Burglar Service Functions".
3. Then, select the following item from the screen menu.
...
Cleaning the Window Interiors
If the windows become covered with an
oily, greasy, or waxy film, clean them with
glass cleaner. Follow the directions on the
container.
CAUTION
Do not scrape or scratch the inside of
the window glass. It could damage the
thermal fi laments and the antenna lines.
When wash ...
Joint Shaft Removal/Installation [Mzr 2.0, Mzr 2.3 Disi Turbo, Mzr 2.5]
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, remove the ABS wheel-speed
sensor connector (axle side) and ...
