Mazda 3 Service Manual: Security & Keyless Entry

PID/Data Monitor Inspection [Blind Spot Monitoring (Bsm)]

1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Module ...

Forced Ignition On [With Advanced Keyless Entry And Push Button Start System]

NOTE: In order to perform a forced ignition ON, the M-MDS (IDS) is necessary. If the servicing is being done outside of an Authorized Mazda dealership, contact an Authorized Mazda dealer ...

Other materials:

Washer Motor Inspection
1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Disconnect the washer motor connector. 4. After connecting washer motor terminal A to the positive battery terminal, and terminal B to the negative battery terminal, verify that washer fluid flows to the wind ...

PID/Data Monitor Inspection [Afs (Adaptive Front Lighting System)]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “AFS”. 3. Select the applicable PID from the PID table. 4. Verify the PID data a ...

Air Filter Removal/Installation [Skyactiv G 2.0]
1. Remove the fuel-filler pipe protector.. 2. Remove in the order indicated in the table. 1 Evaporative hose 2 Air filter 3. Install in the reverse order of removal. ...