Mazda 3 Service Manual: Sensors, Switches, Relays
- Accelerator Pedal Position (App) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Air Fuel Ratio (A/F) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Air Fuel Ratio (A/F) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Camshaft Position (CMP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Camshaft Position (CMP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Crankshaft Position (CKP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Crankshaft Position (CKP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Engine Coolant Temperature (ECT) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Heated Oxygen Sensor (HO2 S) Inspection [Mzr 2.0, Mzr 2.5]
- Heated Oxygen Sensor (HO2 S) Removal/Installation [Mzr 2.0, Mzr 2.5]
- Intake Air Temperature (Iat) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Knock Sensor (Ks) Inspection [Mzr 2.0, Mzr 2.5]
- Knock Sensor (Ks) Removal/Installation [Mzr 2.0, Mzr 2.5]
- Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
- Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]
Voltage Inspection
NOTE:
The variable swirl shutter valve switch cannot be removed as a single unit.
When replacing the variable swirl shutter valve switch, replace it together
with the ...
Voltage Inspection
NOTE:
Because the APP sensor is integrated in the accelerator pedal, replacing
the APP sensor includes replacement of the accelerator pedal.
1. Connect the M-MDS t ...
Other materials:
Relay Inspection [Mzr 2.0, Mzr 2.5, Mzr 2.3 Disi Turbo]
Relay Type
Connector type
Part name
Type A
Front fog light relay
Headlight relay (HI)
Headlight relay (LO)
Horn relay
TNS relay
A/C relay
AT ma ...
Spark Plug Inspection [Mzr 2.0, Mzr 2.5]
Specification
Spark plug type
LFJD-18110, L3Y2-18110
Plug Gap Inspection
CAUTION:
To avoid possible damage to the tip, do not adjust the spark plug gap. (L3Y2-18110)
To prevent damaging the tip, use a wire type plug gap gauge when inspecting
the spark plug gap. (L3 ...
M Position Switch Inspection [FS5 A EL]
1. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the console..
d. Disconnect the selector lever component connector.
2. Inspect the continuity between the selector lever component terminals A and
H.
If ...