Mazda 3 Service Manual: Sensors, Switches, Relays

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]

NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULA ...

Ambient Temperature Sensor Inspection [Full Auto Air Conditioner]

1. Measure the temperature around the ambient temperature sensor and measure the resistance between the ambient temperature sensor terminal. If the characteristics of the ambient tempera ...

Other materials:

Front Stabilizer Removal/Installation [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove the joint cover.. 2. Disconnect the steering shaft from the steering gear and linkage.. 3. Remove the front crossmember component.. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 6. Inspect the wheel alignment and adjust it if necessary ...

Front Door Key Cylinder Switch Inspection
1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inne ...

BSM OFF Indicator Light
This indicator light illuminates for a few seconds when the ignition is switched ON. The BSM OFF indicator light illuminates when the BSM system is turned off by pressing the BSM OFF switch. The indicator light flashes if the BSM system has a malfunction. Consult an Authorized Mazda D ...