Mazda 3 Service Manual: Sensors, Switches, Relays

Parking Brake Switch Inspection

1. Remove the upper panel.. 2. Disconnect the parking brake switch connector. 3. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the ...

Brake Fluid Level Sensor Inspection

1. Disconnect the brake fluid level sensor connector from the master cylinder. 2. Inspect for continuity according to fluid level between the brake fluid level sensor terminals. If no ...

Other materials:

Windshield Defrosting and Defogging
Press the windshield defroster switch. In this position, the outside air position is automatically selected, and the air conditioner automatically turns on. The air conditioner will directly dehumidify the air to the front windshield and side windows (on ). Airflow amount will be increased. ...

Drive Belt Inspection [Mzr 2.0, Mzr 2.5]
MZR 2.0 A/C drive belt NOTE: Drive belt deflection/tension inspection is not necessary because of the use of the maintenance-free type A/C drive belt. Replace the drive belt if it is found to be damaged during visual inspection, or if there is a malfunction or noise in th ...

Replacing a Tire
WARNING Always use tires that are in good condition: Driving with worn tires is dangerous. Reduced braking, steering, and traction could result in an accident. Replace all four tires at the same time: Replacing just one tire is dangerous. It could cause poor handling ...