Mazda 3 Service Manual: Sensors, Switches, Relays

Joint Shaft Removal/Installation [Skyactiv G 2.0]

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]

On-Vehicle Inspection 1. Inspect the power supply circuit for the VSS. a. Remove the insulator from the transaxle. b. Disconnect the VSS connector. c. Switch the ignition to ON (engine ...

Other materials:

Active Adaptive Shift (AAS)
Active Adaptive Shift (AAS) automatically controls the transaxle shift points to best suit the road conditions and driver input. This improves driving feel. The transaxle may switch to AAS mode when driving up and down slopes, cornering, driving at high elevations, or depressing the accelerat ...

Headliner Removal/Installation
1. Shift to the D (ATX) or 4th gear (MTX) position. (4SD) 2. Disconnect the negative battery cable.. 3. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 4. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 5. Partially peel back the seaming ...

Front Scuff Plate Removal/Installation
1. Detach tab A while pulling the front scuff plate in the direction of the arrow (1) shown in the figure, then detach hook B, clips C, and pins D while pulling in the direction of the arrow (2). 2. Detach tab E while pulling the front scuff plate in the direction of the arrow (3) shown in t ...