Mazda 3 Service Manual: Slide Motor Inspection

Mazda 3 Service Manual / Body / Seats / Slide Motor Inspection

1. Remove the battery cover..

2. Disconnect the negative battery cable and wait 1 min or more

3. Disconnect the slide motor connector.

4. Apply battery positive voltage to the slide motor terminals and inspect the slide motor operation

If not as specified, replace the front seat slide adjuster.


Motor operation	Connection
Motor operation	B+	GND
Forward	D	B
Backward	B	D

Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]

CAUTION: When the seat weight sensor is replaced with a new one, perform the seat weight sensor calibration using the M–MDS.. When replacing the seat weight sensor, replace it t ...

Power Seat Switch Inspection

1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the power seat switch connector. 4. Inspect for continuity between the power seat sw ...

Other materials:

Wheel Hub, Steering Knuckle Inspection
Wheel Bearing Excessive Play Inspection 1. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play. If it exceeds the maximum specification, replace the wheel hub bearing. Maximum front wheel bearing play 0.05 mm ...

Picture Quality Adjustment
WARNING Always adjust the picture quality of the rear view monitor while the vehicle is stopped: Do not adjust the picture quality of the rear view monitor while driving the vehicle. Adjusting the picture quality of the rear view monitor such as brightness, contrast, colo ...

Audio Control Switch Operation
Without Bluetooth ® Hands-Free With Bluetooth ® Hands-Free Adjusting the Volume To increase the volume, press up the volume switch ( +). To decrease the volume, press down the volume switch ( -). Seek Switch AM/FM radio Press the seek switch ( , ). The radio switches to the ...