Mazda 3 Service Manual: Solenoid Valve Removal/Installation [FS5 A EL]
WARNING:
-
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.
Primary Control Valve Body
1. Remove the primary control valve body.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the aerodynamic under cover NO.2..
d. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.
e. Drain the ATF..
f. Remove the oil pan..
g. Remove the primary control valve body..
2. Remove in the order indicated in the table.
|
1 |
Bracket |
|
2 |
Shift solenoid A |
|
3 |
Shift solenoid C |
|
4 |
Shift solenoid B |
|
5 |
Shift solenoid E |
|
6 |
Shift solenoid D |
|
7 |
Pressure control solenoid A |
|
8 |
O-ring |
3. Install in the reverse order of removal.
4. Add the ATF..
5. Perform the “Mechanical System Test”..
6. Perform the “Road Test”..
Secondary Control Valve Body
1. Remove the secondary control valve body.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the battery component (ex: battery, battery tray and PCM component)..
d. Remove the aerodynamic under cover NO.2..
e. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.
f. Drain the ATF..
g. Remove the oil cover..
h. Remove the secondary control valve body..
2. Remove in the order indicated in the table.
|
1 |
Bracket |
|
2 |
Pressure control solenoid B |
|
3 |
Shift solenoid F |
|
4 |
O-ring |
3. Install in the reverse order of removal.
4. Add the ATF..
5. Perform the “Mechanical System Test”..
6. Perform the “Road Test”..
Solenoid Valve Inspection [FS5 A EL]
CAUTION:
Water or foreign objects entering the connector can cause a poor connection
or corrosion. Be sure not to drop water or foreign objects on the connector
when disconnecting it.
...
Starter Interlock Switch Inspection [Mzr 2.0, Mzr 2.5]
CAUTION:
Do not reuse the starter interlock switch if it is removed from the vehicle
even once. Replace with a new starter interlock switch when installing.
1. Remove the battery cove ...
Other materials:
Fuel Gauge Sender Unit Removal/Installation
MZR 2.0, MZR 2.5
NOTE:
Fuel pump unit cannot be disassembled.
1. Remove the fuel gauge sender unit..
MZR 2.3 DISI Turbo
NOTE:
Fuel pump unit cannot be disassembled.
1. Remove the fuel gauge sender unit..
SKYACTIV-G 2.0
NOTE:
Fuel pump unit cannot be disasse ...
Trunk Lid Stay Damper Disposal
NOTE:
The gas in the trunk lid stay damper is colorless, odorless, and non-toxic.
1. Wear protective eye wear.
2. Lay the trunk lid stay damper flat.
3. Hacksaw 2—3 mm {0.08—0.11 in} into the trunk lid stay damper
using a hacksaw, and allow the gas to escape from the trunk li ...
Receiving an Incoming Call
When an incoming call is received, the incoming call notification screen is
displayed. The
“Incoming Call Notifications” setting must be on.
Refer to Communication Settings on .
To accept the call, press the pick-up button on the audio control switch or
select on
the screen.
To rejec ...
