Specification
L3BD-18110, L3YD-18110
Plug Gap Inspection
CAUTION:
To avoid possible damage to the tip, do not adjust the plug gap.
To prevent damaging the tip, use a wire type plug gap gauge when inspecting the plug gap.
1. Measure the spark plug gap using a wire type plug gap gauge.
If not within the standard specification, replace the spark plug.
Standard: 0.60—0.80 mm {0.024—0.031 in}
New spark plug (reference): 0.60—0.70 mm {0.024—0.027 in}
Cleaning
CAUTION:
Carbon may adhere to the tip of the spark plug during vehicle delivery or repeated short distance driving during the winter time. If there is any malfunction such as rough idling or start difficulty due to carbon adhesion causing plug fouling, burn off the carbon by performing no-load racing of the engine.
When performing the no-load racing, apply the side brake and foot brake, move the shift lever to neutral to prevent an accident and serious injury.
To avoid possible damage to the spark plug tip, do not use a wire brush for cleaning.
NOTE:
To avoid possible damage to the tip, use gasoline to clean the spark plugs after removing dirt.
If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the PCM control operation, which prevents overheating, and it does not indicate a malfunction.
Do not perform no-load racing at high engine speed continuously for 10 s or more
.
1. If there is carbon adhering to the spark plug, perform no-load racing at 4,000 rpm
for 2 min
, 2 times
.
Visual Inspection
1. Inspect the following items:
If any of the following malfunctions are indicated, replace the spark plug.
Insulator breakage
Worn electrode
Damaged gasket
Badly burned insulator (sparking side)
Resistance Inspection
1. Measure the resistance of the spark plug using a tester as shown in the figure.
If not within specification, replace the spark plug.
3.0—7.5 kilohms
Direct Mode
Direct mode can be used for temporarily
switching gears by operating the steering
shift switch while the vehicle is being
driven with the selector lever in the D
range.
While in direct mode, the D and M
indication illuminate and the gear position
in use is illuminated.
Direct mode is can ...
Front Door Latch And Lock Actuator Inspection
1. The following actuators and switches are integrated with the front door latch
and lock actuator. Inspect the front door latch and lock actuator according to each
inspection procedure for the following items.
Front door lock actuator.
Door lock-link switch.
Door latch s ...
Rear Window Wiper and
Washer
The ignition must be switched ON to use
the wiper.
Rear Window Wiper
Turn the wiper on by turning the rear
wiper/washer switch
Rear Window Washer
To spray washer fluid, turn the rear wiper/
washer switch to the position. After the
switch is released, the washer will stop.
If the w ...