Mazda 3 Service Manual: Starting, Charging

PID/Data Monitor Inspection [Bcm]

1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Module ...

Generator Disassembly/Assembly [Mzr 2.0, Mzr 2.5]

CAUTION: Melt the solder quickly, otherwise the diodes (rectifier) and regulator will be damaged by excessive heat. 1. Disassemble in the order indicated in the table. 2. Assemble i ...

Other materials:

Refrigerant Charging
CAUTION: Do not exceed the specification when charging the system with refrigerant. Doing so will decrease the efficiency of the air conditioner or damage the refrigeration cycle parts. Charging Recycled HFC-134a Refrigerant 1. Connect an HFC-134a recovery/recycling/recharging d ...

Combination Switch Disassembly/Assembly
CAUTION: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. 1. Switch the ignition to off. 2. Disconnect the negative batte ...

Wrench Indicator Light
When the ignition is switched ON, the wrench indicator light is illuminated and then turns off after a few seconds. The wrench indicator light is illuminated when the preset maintenance period arrives. Verify the content and perform maintenance. Refer to Maintenance Monitor on . Low ...