Mazda 3 Service Manual: Steering
- General Procedures (Steering)
- Precaution
- Steering SST
- Steering Switch Inspection
- Steering Switch Removal/Installation
- Linkage, Power
- Air Bleeding
- Electric Power Steering Oil Pump Component Disassembly/Assembly
- Electric Power Steering Oil Pump Component Removal/Installation
- Electro Hydraulic Power Assist Steering (EHPAS) Control Module Configuration
- Electro Hydraulic Power Assist Steering (EHPAS) Control Module Inspection
- Oil Control Valve (OCV) Inspection [Mzr 2.0, Mzr 2.5]
- Oil Control Valve (OCV) Inspection [Mzr 2.3 Disi Turbo]
- Oil Control Valve (OCV) Inspection [Skyactiv G 2.0]
- Oil Control Valve (OCV) Removal/Installation [Mzr 2.0, Mzr 2.5]
- Oil Control Valve (OCV) Removal/Installation [Mzr 2.3 Disi Turbo]
- Oil Control Valve (OCV) Removal/Installation [Skyactiv G 2.0]
- Power Steering Fluid Inspection
- Power Steering Fluid Line Component Removal/Installation
- Steering Shaft Inspection
- Steering Gear And Linkage Assembly
- Steering Gear And Linkage Disassembly
- Steering Gear And Linkage Inspection
- Steering Gear And Linkage Removal/Installation
- Wheel, Column
- Steering Shaft Inspection
- Steering Wheel And Column Inspection
- Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
- Steering Wheel And Column Removal/Installation [Without Advanced Keyless Entry And Push Button Start System]
- Combination Switch Disassembly/Assembly
- Combination Switch Removal/Installation
- No.6 Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
- No.7 Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
Seat Belt Inspection
Belt
1. Verify that the belt is installed properly with no twists or kinks.
2. Verify that there is no damage to the seat belt and no deformation of the
metal fittings.
If there is any ...
General Procedures (Steering)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
88—118 N·m { ...
Other materials:
Seat Warmer Unit Removal/Installation
Removal
WARNING:
Handling a front seat (with built-in side air bag) improperly can accidentally
operate (deploy) the air bag, which may seriously injure you. Read the service
warnings before handling a front seat (with built-in side air bag)..
CAUTION:
After removing a f ...
Mounting the Spare Tire
Remove dirt and grime from the
mounting surfaces of the wheel and
hub, including the hub bolts, with a
cloth.
WARNING
Make sure the mounting surfaces of
the wheel, hub and lug nuts are clean
before changing or replacing tires:
When changing or replacing a tire,
...
Glass Panel Adjustment
1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
If not as specified, loosen the glass panel installation screws and reposition
the glass panel.
Clearance (4SD)
a: -2.4—0.2 mm {-0.09—0.01 in}
b: 0 mm {0 in}
...
