Without Bluetooth System
WARNING:
Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module..
1. Disconnect the negative battery cable and wait for 1 min or more
..
2. Remove the driver-side air bag module..
3. Disconnect the steering switch connector.
4. Verify the resistance between the steering switch terminals.
If not within the specification, replace the steering switch.
5. Apply battery positive voltage to steering switch terminal O, and connect terminal E to ground.
6. Verify that the LED illuminates.
If the LED does not illuminate, replace the steering switch.
With Bluetooth System
WARNING:
Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module..
1. Disconnect the negative battery cable and wait for 1 min or more
..
2. Remove the driver-side air bag module..
3. Disconnect the steering switch connector.
4. Verify the resistance between the steering switch terminals.
If not within the specification, replace the steering switch.
5. Apply battery positive voltage to steering switch terminal O, and connect terminal E to ground.
6. Verify that the LED illuminates.
If the LED does not illuminate, replace the steering switch.
No.7 Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing
Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot
Monitoring (Bsm)]
7
BSM indicator light does not flash while under BSM indicator light-flashing
conditions (with combination switch operation (turn signal switch))
Description
The BSM indicator light does not flash or illuminate continuously,
...
Contact Authorized Mazda Dealer and Have Vehicle Inspected
If any of the following warning lights or the indicator light turns on/flashes, the system may
have a malfunction. Contact an Authorized Mazda Dealer to have your vehicle
inspected.
...
Body Control Module (Bcm) Inspection
1. Remove the following parts:
a. Front scuff plate (LH).
b. Front side trim (LH).
c. Upper panel.
d. Shift knob (MTX).
e. Selector lever knob (ATX).
f. Shift panel.
g. Side wall.
h. Console.
2. Set the hood release lever out of the way..
3. Remove the lower panel. (driver-side). ...