Mazda 3 Owners Manual: Steps for Determining the Correct
Load Limit
Steps for Determining Correct Load Limit-
- Locate the statement “The combined weight of occupants and cargo
should never exceed
XXX kg or XXX lbs.” on your vehicle's placard.
- Determine the combined weight of the driver and passengers that
will be riding in your
vehicle.
- Subtract the combined weight of the driver and passengers from XXX
kg or XXX lbs.
- The resulting figure equals the available amount of cargo and luggage
load capacity. For
example, if the “XXX” amount equals 1400 lbs. and there will be five 150 lb
passengers
in your vehicle, the amount of available cargo and luggage load capacity is
650 lbs.
(1400 - 750 (5 × 150) = 650 lbs.)
- Determine the combined weight of luggage and cargo being loaded on the
vehicle. That
weight may not safely exceed the available cargo and luggage load capacity
calculated in
Step 4.
- If your vehicle will be towing a trailer, load from your trailer will be
transferred to your
vehicle. Consult this manual to determine how this reduces the available
cargo and
luggage load capacity of your vehicle.
WARNING
Do not tow a trailer with this vehicle:
Towing a trailer with this vehicle is dangerous because it has not been
designed to tow a
trailer and doing so will aff ect the driv ...
Keyless Entry System/Immobilizer System
Blind Spot Monitoring (BSM) System
NOTE
During printing time of this user manual the approvals listed above are granted.
WARNING
Change ...
Other materials:
Engine Coolant Temperature (ECT) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until
it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Drain the engine coolant..
4. Remove the battery and b ...
Starter Interlock Switch Inspection [Skyactiv G 2.0]
CAUTION:
Do not reuse the starter interlock switch if it is removed from the vehicle
even once. Replace with a new starter interlock switch when installing.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Disconnect the starter interlock switch connec ...
Purge Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]
Airflow Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the purge solenoid valve..
4. Inspect airflow between the ports under the following conditions.
Measured condition
Continuity between A—B
...