Mazda 3 Service Manual: Suspension

No.7 Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]

7 BSM indicator light does not flash while under BSM indicator light-flashing conditions (with combination switch operation (turn signal switch)) Desc ...

General Procedures (Suspension)

Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening torque 88—118 N·m { ...

Other materials:

Steering Switch Removal/Installation
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. 1. Disconnect the negative battery cable and wait for 1 min or mo ...

Rear Lower Arm Removal/Installation
1. Disconnect the auto leveling sensor link lower side. (Vehicles with AFS). 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the wheel alignment and adjust it if necessary.. 1 Rear coil spring component . ...

Blind Spot Monitoring (Bsm) Off Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the BSM OFF switch.. 3. Verify that the continuity between the BSM OFF switch terminals is as indicated in the table. If the continuity is not as indicated in the table, replace the BSM OFF switch. 4. Apply battery po ...