Mazda 3 manuals

Mazda 3 Service Manual: Suspension SST


49 T034 1A0

Coil spring compressor set


49 0180 510B

Preload measuring attachment


49 B034 001

Guide


49 B034 002

Guide


49 T028 3A0

Ball joint puller set



Rear Wheel Hub Bolt Replacement
1. Remove the brake calliper component and disc plate.. 2. Remove the wheel hub bolt using the SST as shown in the figure. 3. Place a new wheel hub bolt in the wheel hub. 4. Install the whee ...

Wheel Hub Component Inspection
Wheel Bearing Excessive Play Inspection 1. Remove the brake caliper component and disc plate.. 2. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axi ...

Other materials:

Fuel Filler Lid Opener And Lever Removal/Installation
Fuel-filler Lid Opener 4SD 1. Open the fuel-filler lid. 2. Remove the following parts: a. Trunk end trim. b. Trunk side trim (RH). 3. Remove the nut. 4. Remove the lift spring. 5. Pull out the fuel-filler lid opener in the direction of the arrow (1). 6. Disconnect the fue ...

How to use iPod mode (Type A)
An iPod may not be compatible depending on the model or OS version. In this case, an error message is displayed. NOTE The iPod functions on the iPod cannot be operated while it is connected to the unit because the unit controls the iPod functions. Playback Switch the ignition to ACC ...

Power Window Subswitch Inspection
Passenger's Side 1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Remove the front door trim.. 4. Remove the power window subswitch.. 5. Verify that the continuity is as indicated in the table using a tester. If not as indicated in the table, repl ...

© 2016-2024 Copyright www.mazda3tech.com