Mazda 3 manuals

Mazda 3 Owners Manual: Tire Rotation

To equalize tread wear, rotate the tires every 12,000 km (7,500 miles) at the latest or sooner if irregular wear develops. Mazda recommends to rotate every 8,000 km (5,000 miles) to help increase tire life and distribute wear more evenly.

Mazda 3. Tire Rotation


Inspect the tires for uneven wear and damage. Abnormal wear is usually caused by one or a combination of the following:

After rotation, inflate all tire pressures to specification and inspect the lug nuts for tightness.

(With tire pressure monitoring system)

After adjusting the tire pressure, initialization of the tire pressure monitoring system is necessary to make the system operate normally.

Refer to Tire Pressure Monitoring System Initialization on .

CAUTION Rotate unidirectional tires and radial tires that have an asymmetrical tread pattern or studs only from front to rear, not from side to side. Tire performance will be weakened if rotated from side to side.
Tire Maintenance
Improper or inadequate vehicle maintenance can cause tires to wear abnormally. Here are some important maintenance points: Tire Inflation Pressure Inspect all tire pressure monthly (including the ...

Replacing a Tire
WARNING Always use tires that are in good condition: Driving with worn tires is dangerous. Reduced braking, steering, and traction could result in an accident. If a tire wear ...

Other materials:

Caliper (Front) Disassembly/Assembly [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Disassemble in the order indicated in the table. 1 Bleeder cap 2 Bleeder screw 3 Piston (See Piston Disassembly Note.) (See Piston Assembly Note.) 4 Dust seal (See Dust Seal ...

Split/One-piece Folding the Seatback
By lowering the rear seatback(s) the luggage compartment space can be expanded. WARNING Do not drive the vehicle with occupants on folded down seatback(s) or in the luggage compartment. Putting occupants in the luggage compartment is dangerous because seat belts cannot be ...

Oil Seal (Differential) Replacement [A26 M R]
1. On level ground, jack up the vehicle and support it evenly on safety stands. 2. Drain the oil from the transaxle.. 3. Remove the front tires.. 4. Remove the splash shield.. 5. Remove the aerodynamic under cover No.2.. 6. Separate the drive shaft and joint shaft from the transaxle.. 7 ...

© 2016-2024 Copyright www.mazda3tech.com