WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.
1. Remove the primary control valve body.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the aerodynamic under cover NO.2..
d. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.
e. Remove the air cleaner component..
f. Disconnect the coupler component connector.
g. Drain the ATF..
h. Remove the oil pan.
i. Remove the primary control valve body..
2. Remove the coupler component from transaxle case.
3. Remove the O-ring from the coupler component.
4. Install the primary control valve body.
a. Apply ATF to a new O-ring and install it on the coupler component.
b. Install the coupler component to transaxle case.
c. Connect the coupler component connector.
d. Install the primary control valve body..
5. Apply a light coat of silicon sealant (TB1217E) to the contact surfaces of the oil pan and transaxle case.
CAUTION:
If any sealant remains on the sealing surfaces of the transaxle case and oil pan, transaxle damage may occur. Use a cleaning fluid to remove any old sealant from the transaxle case and oil pan.
6. Install the oil pan before the applied sealant starts to harden.
6—8 N·m {62—81 kgf·cm, 54—70 in·lbf}
7. Add the ATF..
8. Install the aerodynamic under cover NO.2..
9. Install the air cleaner component..
10. Connect the negative battery cable.
11. Install the battery cover..
12. Perform the “Mechanical System Test”..
Oil Control Valve (OCV) Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the plug hole plate..
4. Disconnect the wiring harness.
5. Remove the ignition coils..
6. Remove the ventilation hose.
7. Remove the oil level gauge.
8. Remove the cylinder head cover..
9. Remove in th ...
Climate Control Unit Disassembly/Assembly [Manual Air Conditioner]
1. Disassemble in the order indicated in the figure.
1
Dial
2
Airflow mode wire
(See Wire Removal Note.)
(See Wire Installation Note.)
3
Air mix wire
(See Wire Removal Note.)
(See Wire Installation Note ...
Hole Cover Removal/Installation
With Car-navigation system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Upper column cover.
b. Instrument cluster.
c. Center panel.
d. Center cover.
e. Dashboard upper panel.
f. Multi information display.
3. Pull the hole cover in the direction of arr ...