Mazda 3 Service Manual: Transaxle Oil Inspection [A26 M R]

Mazda 3 Service Manual / Engine / Lubrication / Transaxle Oil Inspection [A26 M R]

1. Park the vehicle on level ground.

2. Remove the aerodynamic under cover No.2..

3. Remove the oil level plug and gasket.

4. Verify that the oil is near the brim of the plug port.

If the oil level is lower than the low level, add the specified amount and type of oil through the oil level plug hole.

Manual transaxle oil


Item	Specification
Grade	API service GL-4
Viscosity	SAE 75W-80

5. Install a new gasket and the oil level plug.

Tightening torque

28—51 N·m {2.9—5.2 kgf·m, 21—37 ft·lbf}

6. Install the aerodynamic under cover No.2..

Rear Oil Seal Replacement [Mzr 2.0, Mzr 2.5]

1. Remove the transaxle.. 2. Remove the flywheel (MTX) or the drive plate (ATX).. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 ...

Transaxle Oil Inspection [G35 M R]

1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and washer. 4. Verify that the oil is near the brim of the plug port. I ...

Other materials:

Daytime Running Lights
Some countries require moving vehicles to have their lights on (daytime running lights) during the daytime. Daytime running lights turn on automatically when the ignition is switched ON. They turn off when the parking brake is operated or the shift lever is shifted to the P position (aut ...

Cooling System Service Warnings [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Intake Air Temperature (Iat) Sensor Inspection [Mzr 2.0, Mzr 2.5]
Resistance Inspection NOTE: Because the IAT sensor is integrated in the MAF sensor, replacing the IAT sensor includes replacement of the MAF/IAT sensor. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the MAF/IAT sensor connector. 4. Mea ...