Mazda 3 Service Manual: Transaxle Oil Replacement [A26 M R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2..
3. Remove the drain plug and gasket.
4. Drain the oil into a suitable container.
5. Install a new gasket and the drain plug.
-
Tightening torque
-
28—51 N·m {2.9—5.2 kgf·m, 21—37 ft·lbf}
6. Remove the oil level plug and gasket.
7. Add the specified amount and type of oil through the oil level plug hole until the level reaches the bottom of the oil level plug hole.
Manual transaxle oil
|
Item |
Specification |
|
Grade |
API service GL-4 |
|
Viscosity |
SAE 75W-80 |
|
Capacity (approx. quantity) |
2.4—2.6 L {2.6—2.7 US qt, 2.12—2.28 lmp qt} |
8. Install a new gasket and the oil level plug.
-
Tightening torque
-
28—51 N·m {2.9—5.2 kgf·m, 21—37 ft·lbf}
9. Install the aerodynamic under cover No.2..
Transaxle Oil Inspection [G66 M R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2..
3. Remove the oil level plug and washer.
4. Verify that the oil is near the brim of the plug port.
I ...
Transaxle Oil Replacement [G35 M R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2..
3. Remove the drain plug and washer.
4. Drain the oil into a suitable container.
5. Install a new washer a ...
Other materials:
Manual Transaxle Shift Mechanism Removal/Installation [G66 M R]
1. Remove the battery cover..
2. Disconnect the negative battery cable.
3. Remove the battery component. (ex: battery, battery tray and PCM component).
4. Remove the air cleaner component..
5. Remove the aerodynamic under cover NO.2..
6. Remove the tunnel member (rear)..
7. Remove the u ...
Air Bypass Valve Inspection [Mzr 2.3 Disi Turbo]
1. Remove the air bypass valve..
2. Connect the vacuum pump to the vacuum ports of the air bypass valve.
3. Verify that the airflow is as indicated in the table.
Vacuum
(kPa {mmHg, inHg})
Valve operation condition
Airflow between port A—B
...
Liftgate Upper Trim Removal/Installation
1. Detach tab while pulling the liftgate upper trim in the direction of the arrow
(1) shown in the figure, then detach clips and pin while pulling in the direction
of the arrow (2).
2. Detach tab while pulling the liftgate upper trim in the direction of the arrow
(3) shown in the figure, ...
