CAUTION:
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.
1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
2. Shift the selector lever to the N position.
3. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the air cleaner component..
d. Disconnect the TR switch connector.
4. Loosen the TR switch.
a. Remove the clip from the selector cable.
b. Disconnect the selector cable from manual shaft lever.
c. Loosen the TR switch installation bolts.
5. Adjust the TR switch.
a. Verify that the manual shaft is aligned with the N position.
b. Adjust the TR switch between terminals B and C until the resistance becomes specification.
713—787 ohms
c. Tighten the TR switch installation bolts.
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}
Seat Precautions
WARNINGMake sure the adjustable components of a seat
are locked in place:
Adjustable seats and seatbacks that are not securely locked are
dangerous. In a
sudden stop or collision, the seat or seatback could move, causing
injury. Make sure the
adjustable components of the ...
Engine Removal/Installation [Skyactiv G 2.0]
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
Fuel vapor is hazardous. It can very easily ignite, causing serious injury
and damage. Always keep sparks and flames away from fuel.
Fuel line spills and leakag ...
High Mount Brake Light Bulb Removal/Installation
4SD
1. Disconnect the negative battery cable..
2. Remove the trunk lid trim..
3. Remove in the order indicated in the table.
1
Connector
2
Socket
3
High-mount brake light bulb
4. Install in the rev ...