CAUTION:
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.
Operation Inspection
1. Perform the following procedures to inspect the TR switch.
If there is any malfunction, adjust the TR switch..
a. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
b. Verify that the starter operates only when the ignition is switched to START with the selector lever in the P position or the N position.
c. Verify that the back-up lights illuminate when shifted to the R position with the ignition at ON.
d. Verify that the positions of the selector lever and the selector indicator light are aligned.
On-Vehicle Inspection
1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
2. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the air cleaner component..
d. Disconnect the TR switch connector.
3. Inspect continuity as indicated in the table.
If there is any malfunction, adjust the TR switch..
Warning Lights
These lights turn on or flash to notify the user of the system operation
status or a system
malfunction.
Signal
Warning Lights
Master Warning Light *1
Brake System Warning Light *1*2
ABS Warning Light *1
Charging System Warnin ...
Body And Accessories
ABBREVIATIONS
ACC
Accessories
AUX
Auxiliary jack
CAN
Controller Area Network
DLC
Data Link Connector
GND
Ground
LH
Left Hand
...
Outside Temperature Display
When the ignition is switched ON, the
outside temperature is displayed.
NOTE
Under the following conditions, the
outside temperature display may differ
from the actual outside temperature
depending on the surroundings and vehicle
conditions:
Significantly cold or hot
temperatures.
...