1. Disconnect the negative battery cable..
2. Disengage the tabs by pressing both ends of the lens in the directions indicated by the arrows and remove the lens.
3. Remove the trunk compartment light bulb.
4. Install in the reverse order of removal.
Fuel Filler Lid Opener Cable Removal/Installation
4SD
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front seat (LH).
b. Front scuff plate (LH).
c. Rear scuff plate.
d. B-pillar lower trim.
e. Rear seat cushion.
f. Rear seat back.
g. Tire house trim.
h. Trunk end trim.
i. Trunk side trim (RH).
j. ...
Power Brake Unit Inspection
NOTE:
The following inspection methods are simple inspection methods to judge the
function of the power brake unit.
If there is any malfunction in the power brake unit, replace the power brake
unit as a single unit.
Without Using SST
Operation inspection
1. With the eng ...
Trunk Lid Release Actuator Inspection
1. Disconnect the negative battery cable..
2. Remove the trunk lid trim..
3. Remove the trunk lid latch and release actuator..
4. Press the latch in using a flathead screwdriver to inspect the latch lever
condition.
5. Connect terminal A to the positive battery voltage, connect termina ...