Mazda 3 Service Manual: Trunk Lid Adjustment
1. Measure the gap and height difference between the trunk lid and the body.
-
Standard clearance
-
a: 2.44.4 mm {0.100.17 in}
-
b: -4.6-2.6 mm {-0.18-0.11 in}
-
c: 2.54.5 mm {0.100.17 in}
-
d: -1.70.3 mm {-0.060.01 in}
-
e: 2.64.6 mm {0.110.18 in}
-
f: -1.80.2 mm {-0.0700.007 in}
-
g: 2.36.3 mm {0.100.24 in}
-
h: -2.02.0 mm {-0.0780.078 in}
-
i: 4.08.0 mm {0.160.31 in}
2. Loosen the trunk lid hinge installation bolts or nuts and adjust the trunk lid.
-
If necessary, loosen the trunk lid lock striker installation bolts and adjust the trunk lid..
3. Tighten the bolts or nuts..
Trunk End Trim Removal/Installation
4SD
1. Remove the trunk mat..
2. Remove the trunk board..
3. Remove the fasteners.
4. Pull the trunk end trim indicated in the arrow shown in the figure, then detach
clips A, pins B, pin C, D ...
Trunk Lid Key Cylinder Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the trunk lid trim..
3. Lift the clip in the direction of the arrow (1), and pull out the key rod
in the direction of the arrow (2).
4. ...
Other materials:
PID/Data Monitor Inspection [Two Step Deployment Control System]
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the IDS.
a. Select DataLogger.
b. Select Modules.
c. Select RCM.
3. Select the applicable PID from the PID table.
4. Verify the PID data a ...
Windshield Wiper Motor Disassembly/Assembly
1. Disassemble in the order indicated in the table.
1
Wiper link No.1
(See Ball Joint Assembly Note.)
2
Wiper link No.2
(See Ball Joint Assembly Note.)
3
Nut
4
Washer
...
No.27 Fuel Refill Concerns [Mzr 2.0, Mzr 2.5]
27
FUEL REFILL CONCERNS
DESCRIPTION
Fuel tank does not fill smoothly.
POSSIBLE CAUSE
PCM DTC is stored
Nonreturn valve malfunction
Improper use of fuel ...
