Mazda 3 Service Manual: Trunk Lid Latch And Release Actuator Inspection
1. The following actuator and switch are integrated with the release actuator. Inspect the trunk lid latch and release actuator according to each inspection procedure for the following items.
-
Trunk lid latch switch.
-
Trunk lid release actuator.
Trunk Lid Key Cylinder Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the trunk lid trim..
3. Lift the clip in the direction of the arrow (1), and pull out the key rod
in the direction of the arrow (2).
4. ...
Trunk Lid Latch And Release Actuator Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the trunk lid trim..
3. Disconnect the connector.
4. Remove the bolts.
5. Remove the trunk lid latch and release actuator.
6. Ins ...
Other materials:
How to use USB mode (Type B)
Type
Playable data
USB mode
MP3/WMA/AAC/OGG file
This unit does not support a USB 3.0 device. In addition, other devices may
not be
supported depending on the model or OS version.
USB devices formatted to FAT32 are supported (USB devices formatted to other
...
Input/Turbine Speed Sensor Inspection [FS5 A EL]
CAUTION:
Water or foreign objects entering the connector can cause a poor connection
or corrosion. Be sure not to drop water or foreign objects on the connector
when disconnecting it.
On-Vehicle Inspection
1. Perform the following procedures.
a. Remove the battery cover..
b. ...
Drive Shaft (Double Offset Joint) Disassembly/Assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
1
Boot band (transaxle side)
(See DRIVE SHAFT (TRIPOD JOINT) DISASSEMBLY/ASSEMBLY.)
2
Outer ring
(See Outer Ring, Clip Assembly Note. ...
