Mazda 3 manuals

Mazda 3 Service Manual: Trunk Lid Opener Switch Inspection

Mazda 3 Service Manual / Body / Doors/Lids & Hood/Trunk / Trunk Lid Opener Switch Inspection

1. Disconnect the negative battery cable..

2. Remove the trunk lid trim..

3. Remove the high-mount brake light..

4. Remove the trunk lid opener switch..

5. Verify the continuity of trunk lid opener switch terminals A and B.


6. Verify that the continuity is as indicated in the table.


Trunk Side Upper Trim Removal/Installation
1. Remove the rear seat cushion.. 2. Remove the rear scuff plate.. 3. Remove the tire house trim.. 4. Open the cap. 5. Remove the screw. 6. Remove the fasteners. 7. Pull the trunk side upp ...

Trunk Lid Opener Switch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Remove the high-mount brake light.. 4. Remove the screw. 5. Install in the reverse order of removal. ...

Other materials:

Dashboard Precautions
Prevent caustic solutions such as perfume and cosmetic oils from contacting the dashboard. They will damage and discolor the dashboard. If these solutions get on the dashboard, wipe them off immediately. CAUTION Do not use glazing agents. Glazing agents contain ingredients which ...

Basic Inspection [FS5 A EL]
STEP INSPECTION ACTION 1 Measure the battery voltage. Is the battery voltage 10.0—14.0 V? Yes Go to the next step. No Replace or recharge the battery. (See BATTERY RECHARG ...

Warm Up Three Way Catalytic Converter (Wu Twc) Inspection [Mzr 2.0, Mzr 2.5]
CAUTION: Perform the following procedures, DTC P0421:00 is indicated only. 1. Connect the M-MDS to the DLC-2. 2. Start the engine and warm it up to normal operating temperature. 3. Turn off the engine. 4. Verify that the engine compression is within the specification.. ...

© 2016-2025 Copyright www.mazda3tech.com