Mazda 3 manuals

Mazda 3 Service Manual: Trunk Side Upper Trim Removal/Installation

Mazda 3 Service Manual / Body / Doors/Lids & Hood/Trunk / Trunk Side Upper Trim Removal/Installation

1. Remove the rear seat cushion..

2. Remove the rear scuff plate..

3. Remove the tire house trim..

4. Open the cap.

5. Remove the screw.

6. Remove the fasteners.

7. Pull the trunk side upper trim in the direction of arrow, then detach the hooks and clips.


8. Install in the reverse order of removal.

Trunk Side Trim Removal/Installation
4SD Left-side 1. Remove the following parts: a. Rear scuff plate. b. Tire house trim. c. Trunk mat. d. Trunk board. e. Trunk end trim. f. Service hole cover 2. Remove the fasteners. ...

Trunk Lid Opener Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Remove the high-mount brake light.. 4. Remove the trunk lid opener switch.. 5. Verify the continuity of trunk lid o ...

Other materials:

Relay Inspection [Skyactiv G 2.0]
Relay Type Connector type Part name Type A Front fog light relay Headlight relay (HI) Headlight relay (LO) Horn relay TNS relay A/C relay Start ...

Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
WARNING: Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings before handling the air bag module.. 1. Remove the driver-side front scuff plate.. 2. Remove the driver-side front sid ...

TCM Configuration [Fw6 A EL]
NOTE: The TCM is built into the control valve body. 1. Verify TCM configuration implementation necessity for replacement parts. Replacement part Configuration necessity Control valve body replacement Necessary ...

© 2016-2024 Copyright www.mazda3tech.com