Mazda 3 Service Manual: Vacuum Pump Inspection [Skyactiv G 2.0]
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump.
2. Install the vacuum gauge as shown in the figure, then check the vacuum.
3. Warn up the engine.
-
If the pressure is less than the specification, inspect for the following.
-
Malfunction of the vacuum pump
-
Shortage of the lubrication oil pressure
|
Measurement condition |
Specification |
|
|
Engine speed |
Change in vacuum amount |
Period of time change in vacuum amount condition met |
|
While idling (520—700 rpm (reference value)) |
From 60 kPa {450 mmHg, 18 inHg} to 67 kPa {503 mmHg, 20 inHg} |
8 s or less |
Vacuum pump maximum vacuum specification (reference value) (SKYACTIV-G 2.0)
|
Measurement condition |
Specification |
|
While idling (no time designation) |
93.3 kPa {700 mmHg, 27.6 inHg} or more |
4. Install in the reverse order of the removal.
Vacuum Line Inspection
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo
1. Remove the vacuum hose..
2. Verify that air can be blown from the power brake unit side of the vacuum
hose towards the intake manifold side, and that air c ...
Vacuum Pump Removal/Installation [Skyactiv G 2.0]
1. Remove the plug hole plate..
2. Remove the battery and battery tray..
3. Pinch open the clamp using pliers and disconnect the vacuum hose from the
vacuum pump.
4. Remove in the order sh ...
Other materials:
Rear Brake (Disc) Inspection
Brake Judder Repair Hints
Description
1. Brake judder concern has the following 3 characteristics:
Steering wheel vibration
1. The steering wheel vibrates in the rotation direction. This characteristic
is most noticeable when applying brakes at a vehicle speed of 100—140 km/h {62.2—86.9
mph ...
Power Window System Preliminary Inspection [Power Window System]
Manual Open/close Function Inspection
STEP
INSPECTION
ACTION
1
Switch the ignition to ON.
Operate the power window using the manual open/close function on
the power window main switch.
...
Up Switch Inspection [FS5 A EL]
1. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the console..
d. Disconnect the selector lever component connector.
2. Inspect the continuity between the selector lever component terminals B and
H.
If ...
