CAUTION:
Variable valve timing actuator can not be disassembled because it is a precision unit.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the plug hole plate..
4. Disconnect the wiring harness.
5. Remove the ignition coils..
6. Remove the spark plugs..
7. Remove the ventilation hose.
8. Remove the oil level gauge.
9. Remove the cylinder head cover..
10. Inspect the variable valve timing actuator for damage around the stopper pin cap (A), or a missing stopper pin cap (B), spring and stopper.
If no parts are damaged or missing, go to the next step.
If any parts are damaged or missing, replace the variable valve timing actuator..
CAUTION:
If any parts are damaged or missing, remove the front cover to inspect the timing and oil pump chains and all related components for damage as a result of lost parts. Replace components if necessary.
If the lost parts cannot be located in the timing chain area, it will be necessary to remove the oil pan to retrieve them.
11. Turn the crankshaft clockwise so that the notches on the variable valve timing actuator can be checked.
12. Turn the camshaft counterclockwise to align the notches on the variable valve timing actuator.
13. With the notches aligned, turn the camshaft clockwise 30 degrees.
14. Verify the notches again.
A: If the notches are not aligned, replace the variable valve timing actuator..
B: If the notches are aligned, there is no problem with the variable valve timing actuator.
NOTE:
In some rare cases, the timing chain tensioner ratchet lock may get stuck, which will require the removal of the engine front cover.
15. Install in the reverse order of removal.
Front Stabilizer Removal/Installation [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove the joint cover..
2. Disconnect the steering shaft from the steering gear and linkage..
3. Remove the front crossmember component..
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Inspect the wheel alignment and adjust it if necessary ...
Windshield Wipers and Washer
The ignition must be switched ON to use
the wipers.
WARNING
Use only windshield washer fl uid or
plain water in the reservoir:
Using radiator antifreeze as washer
fl uid is dangerous. If sprayed on the
windshield, it will dirty the windshield,
aff ect your visibility, and ...
Saving Fuel and Protection of the
Environment
How you operate your Mazda determines
how far it will travel on a tank of fuel. Use
these suggestions to help save fuel and
reduce CO2.
Avoid long warm-ups. Once the engine
runs smoothly, begin driving.
Avoid fast starts.
Drive at lower speeds.
Anticipate when to apply the brakes
(a ...