CAUTION:
Variable valve timing actuator cannot be disassembled because it is a precision unit.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the charge air cooler..
4. Remove the ignition coils..
5. Disconnect the ventilation hose from the cylinder head cover..
6. Remove the cylinder head cover..
7. Inspect the variable valve timing actuator for damage around the stopper pin cap (A), or a missing stopper pin cap (B), spring and stopper.
If no parts are damaged or missing, go to the next step.
If any parts are damaged or missing, replace the variable valve timing actuator..
CAUTION:
If any parts are damaged or missing, remove the front cover to inspect the timing and oil pump chains and all related components for damage as a result of lost parts. Replace components if necessary.
If the lost parts cannot be located in the timing chain area, it will be necessary to remove the oil pan to retrieve them.
8. Turn the crankshaft clockwise so that the notches on the variable valve timing actuator can be checked.
9. Turn the camshaft counterclockwise to align the notches on the variable valve timing actuator.
10. With the notches aligned, turn the camshaft clockwise 30 degrees.
11. Verify the notches again.
A: If the notches are not aligned, replace the variable valve timing actuator..
B: If the notches are aligned, there is no problem with the variable valve timing actuator.
NOTE:
In some rare cases, the timing chain tensioner ratchet lock may get stuck, which will require the removal of the engine front cover.
12. Install in the reverse order of removal.
Rear ABS Wheel Speed Sensor Inspection
Installation Visual Inspection
1. Inspect for the following:
If there is any malfunction, replace the part.
a. Excessive looseness or play of the rear ABS wheel-speed sensor
b. Deformation of the rear ABS wheel-speed sensor
c. Deformation or damage of the rear ABS sensor rotor
C ...
Center Panel Removal/Installation
1. Disconnect the negative battery cable..
2. Affix protective tape to the position shown in the figure.
3. Hold parts (A) shown in the figure with your hands and pull the lower edge
of the center panel in the direction of the arrow (1), and remove clips A.
CAUTION:
Be careful no ...
Headlight Bulb Removal/Installation
Halogen Type
Low-beam
1. Disconnect the negative battery cable..
2. Disconnect the connector.
3. Remove the cover.
4. Remove the adaptor.
5. Remove the headlight bulb (LO).
CAUTION:
A halogen bulb generates extremely high heat when it is illuminated. If the
surface of ...