NOTE Warranty information varies depending on the country. Refer to the Warranty Booklet for detailed warranty information.
Warranty
Outside the United States/
CanadaSeat Weight Sensor Calibration [Two Step Deployment Control System]
CAUTION:
If any of the following work is performed, perform the seat weight sensor
calibration using the M-MDS.
Replacement with a new seat weight sensor
Replacement with a new seat weight sensor control module
Replacement with new passenger-side seat pa ...
Washer Fluid Level Sensor Inspection
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Verify that continuity between the washer fluid-level sensor terminals is
as indicated in the table.
If not as specified, replace the washer fluid-level sensor.
...
Rear Door Checker Removal/Installation
1. Fully close the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the rear door trim..
4. Remove the rear door speaker..
5. Remove the bolt A.
6. Remove the bolts B.
7. Pull out the rear door checker from the rear door speaker installation hole.
8. Insta ...