Mazda 3 Service Manual: Wheel Hub Component Removal/Installation
CAUTION:
-
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
|
1 |
ABS wheel-speed sensor connector |
|
2 |
ABS wheel-speed sensor |
|
3 |
Rear parking brake cable (See PARKING BRAKE LEVER REMOVAL/INSTALLATION.) |
|
4 |
Brake caliper component (See Brake Caliper Component Removal Note.) (See REAR BRAKE (DISC) REMOVAL/INSTALLATION.) |
|
5 |
Disc plate |
|
6 |
Wheel hub component |
|
7 |
Dust cover |
|
8 |
Wheel hub bolt (See Wheel Hub Bolt Removal Note.) (See Wheel Hub Bolt Installation Note.) |
Brake Caliper Component Removal Note
1. Remove the retaining clip and mounting support installing bolt.
2. Remove the brake caliper component from the trailing link and suspend it out of the way using a cable.
Wheel Hub Bolt Removal Note
NOTE:
-
The hub bolts do not need to be removed unless they are being replaced.
1. Remove the hub bolt using a press.
Wheel Hub Bolt Installation Note
1. Install the new hub bolt using a press.
Wheel Hub Component Inspection
Wheel Bearing Excessive Play Inspection
1. Remove the brake caliper component and disc plate..
2. Install the magnetic base and dial gauge as shown in the figure and measure
the wheel bearing axi ...
Front Suspension
...
Other materials:
Oil Cooler Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous.
It can slip or fall, causing death or serious injury. Never work ...
Theft Deterrent System Reading Freeze Frame Data
1. Connect the M-MDS (IDS) to the DLC–2.
2. After the vehicle is identified, select the following items from the initialization
screen of the IDS.
Select “Body”.
Select "Burglar Service Functions".
3. Then, select the following item from the screen menu.
...
Blind Spot Monitoring (Bsm) Bracket Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the rear combination light..
3. Remove the rear bumper..
4. Remove the BSM control module..
5. Remove the nuts.
6. Remove the clip.
7. Remove the BSM bracket.
8. Install in the reverse order of removal.
9. Perform the blind ...
