1. Operate the windshield wipers, and then turn off the windshield wiper motor to set the wipers in the auto stop position.
2. Slide the serrated connecting part and adjust the windshield wiper arm and blade so that its end is aligned with the hollowed mark in the ceramic coating.
NOTE:
If the hollowed mark in the ceramic coating cannot be located, measure the distance from the cowl grille end line, and adjust the windshield wiper arm and blade.
Front Shock Absorber And Coil Spring Disassembly/Assembly
WARNING:
Removing/installing the shock absorber and coil spring is dangerous. The
shock absorber and coil spring could fly off and cause serious injury or death,
and damage the vehicle.
1. Remove the front shock absorber and coil spring..
2. Remove in the order indicated in the ...
Transaxle Oil Inspection [A26 M R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2..
3. Remove the oil level plug and gasket.
4. Verify that the oil is near the brim of the plug port.
If the oil level is lower than the low level, add the specified amount and
type of oil through the ...
ABS HU/CM Inspection
1. Disconnect the ABS HU/CM connector..
2. Connect the negative battery cable..
3. Attach the tester lead to the ABS HU/CM wiring harness-side connector and
inspect the voltage, continuity, or resistance according to the standard (reference
value) in the table below.
Standard (reference)
...