Mazda 3 Service Manual: Windshield Wiper Arm And Blade Removal/Installation
1. Remove in the order indicated in the table.
|
1 |
Cap |
|
2 |
Nut |
|
3 |
Windshield wiper arm (See Windshield Wiper Arm Installation Note.) |
|
4 |
Windshield wiper blade |
|
5 |
Rubber brush |
|
6 |
Backing plate |
2. Install in the reverse order of removal.
3. Adjust the windshield wiper arm and blade..
Windshield Wiper Arm Installation Note
1. Clean the windshield wiper arm connector shafts using a wire brush before installing the windshield wiper arms.
Windshield Wiper Arm And Blade Adjustment
1. Operate the windshield wipers, and then turn off the windshield wiper motor
to set the wipers in the auto stop position.
2. Slide the serrated connecting part and adjust the windshield wiper ar ...
Windshield Wiper Motor Disassembly/Assembly
1. Disassemble in the order indicated in the table.
1
Wiper link No.1
(See Ball Joint Assembly Note.)
2
Wiper link No.2
(See Ball Joint ...
Other materials:
Up Switch Inspection [Fw6 A EL]
Continuity Inspection
NOTE:
The up switch is built into the selector lever component.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the console..
4. Disconnect the selector lever component connector.
5. Verify that the continuity betwee ...
Lower Panel Removal/Installation
Driver-side
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Driver-side front scuff plate.
b. Driver-side front side trim.
c. Hood release lever.
d. Upper panel.
e. Shift knob (MTX).
f. Selector lever knob (ATX).
g. Shift panel.
h. Side wall.
i. Cons ...
Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]
ECT Sensor No.1
Resistance inspection
WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until
it is cool before removing the ECT sensor.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Drain the engine coolant..
4. R ...
