Mazda 3 Service Manual: Windshield Wiper Motor Disassembly/Assembly
1. Disassemble in the order indicated in the table.
|
1 |
Wiper link No.1 (See Ball Joint Assembly Note.) |
|
2 |
Wiper link No.2 (See Ball Joint Assembly Note.) |
|
3 |
Nut |
|
4 |
Washer |
|
5 |
Crank arm |
|
6 |
Bolt |
|
7 |
Windshield wiper motor |
|
8 |
Main link (See Ball Joint Assembly Note.) |
|
9 |
Windshield wiper motor cover No.1 |
|
10 |
Windshield wiper motor cover No.2 |
2. Assemble in the reverse order of disassembly.
Windshield Wiper Motor Assembly Note
1. Connect the windshield wiper motor to the vehicle wiring harness connector, operate the windshield wipers, and then stop them at the auto stop position.
2. Disconnect the windshield wiper motor connector.
3. Install the windshield wiper motor to the main link and tighten the bolt.
4. Assemble the crank arm such that the crank arm and main link markings are aligned as shown in the figure.
5. Install the washer and nut.
Ball Joint Assembly Note
1. Use a clean cloth to protect the link, and squeeze using pliers.
Windshield Wiper Arm And Blade Removal/Installation
1. Remove in the order indicated in the table.
1
Cap
2
Nut
3
Windshield wiper arm
(See Windshield Wiper Arm Ins ...
Windshield Wiper Motor Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Front fender molding.
c. Cowl grille.
d. Center cowl grille No.1, No.2
3. Di ...
Other materials:
Air Intake Actuator Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C),
connect terminal C (or B) to ground, and then verify that the air intake actuator
operates as shown in the table.
If the operation condition is not normal, replace the air intake actuator.
...
Front Center Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Upper column cover.
b. Instrument cluster.
c. Center panel.
d. Center cover.
e. Dashboard upper panel.
f. Front center speaker.
3. Verify the resistance between the front center speaker terminals.
...
Settings
NOTE
Depending on the grade and specification, the screen display may differ.
Select the icon on the home
screen and display the Settings screen.
Switch the tab and select the setting item you want to change.
You can customize settings in the setup display as follows:
Tab
...
